How to Make Stun Guns

How to Make Stun Guns by Yourself

Now you can make homemade stun guns by yourself, as we know, the electric stun gun has become more and more popular and legal in our life, there are many people would choose the stun gun as their self-defense weapon. General stun guns available in the market will cost too high, why not make a stun gun by yourself？We will make simple introduction for the detailed method of free homemade stun guns. Please read on:

Necessary Tools:
Disposable camera with flash, Wire strippers, Wires, screwdriver, Soldering Iron
Step one: Dismantling the camera;
The Tools required is screwdriver, you must be carefully, don’t break any part of the camera. To pry the camera open with the screwdriver, you will see small tabs on the back of the camera, at the bottom and top.
Tips：Must remove the battery or discharge any electricity that may be in the flash bulb of the camera before dismantlement
Necessary Tools:
Disposable camera with flash, Wire strippers, Wires, screwdriver, Soldering Iron

Step one: Dismantling the camera;
The Tools required is screwdriver, you must be carefully, don’t break any part of the camera. To pry the camera open with the screwdriver, you will see small tabs on the back of the camera, at the bottom and top.
Tips：Must remove the battery or discharge any electricity that may be in the flash bulb of the camera before dismantlement

Step two: Remove the small circuit out of camera;
At the step, we will see the main structure of camera inside, equipped with a small green board directly connected to the flash bulb and a small capacitor, and the bulb powered by the board. The capacitor have the same shape as a copper, so usually we call it copper. Seriously discard and remove the 3/4 inch light bulb freely if you have no other use.

Step three:Make the connected wire;As need two wires,one is used on speaker,you must split one end of the wires in two,and each wire about 1″-1 1/2″
Tips：Twist each wire tightly to ensure that there are no stray wires coming out.
Step Four: Solder the wire on capacitor; There are two pieces of capacitor on both sides of the the light bulb, then connect one wire to either side of capacitor, you can solder a black wire to one of the capacitor pieces ,solder another red wire to the other capacitor piece. Remember: bend each wire over its respective capacitor wire and tightly twist it,and the wires should be twisted as tightly as possible.

Step Five: Replace the circuit board and drill holes, it is very simple but you must be very carefully; The first, you drill two small holes on the left side of the camera surface, then you must place the circuit back into the camera, at the same time let the wires hang out of holes, twist the ends of these wires to ensure that there are no frays in the wires, split the two wires with the other end of the speaker wire,the last is reassemble the camera and use glue to hold it.
Step six: Reinsert the battery and press the button; There will a small arc of electricity coming from the protruding wires, but don’t touching the wires.

Warnings:
1. Must wearing rubber gloves to avoid getting shocked before make stun guns
2. Don’t use this stun gun on vulnerable groups , such as babies,or anyone else that may have an adverse effect from being shocked, even with the lovely animal.
“How to Make Stun Guns by Yourself”,the answer is “Yes,you can DIY!”, Make stun guns is so easy, but must be very careful.

Camera, electric stun gun, homemade stun gun, Stun gun

must be very careful.